Loading of an UPSD3354DV Flash dump into IDA Pro

		Exetools > General > Electric Section
Loading of an UPSD3354DV Flash dump into IDA Pro

01-13-2024, 03:25

souz

Friend

Join Date: Jan 2005

Posts: 134

Rept. Given: 0

Rept. Rcvd 26 Times in 18 Posts

Thanks Given: 13

Thanks Rcvd at 86 Times in 35 Posts

Start from this:

After a power-up or reset, the 8032 begins program execution from location 0x0000 where the
reset vector is stored, causing a jump to an initialization routine in firmware. At address 0x0003, just
following the reset vector are the interrupt service
locations

Quote:

code:0000D548 RESET_0: ; CODE XREF: RESET↑j
code:0000D548 movx A, @DPTR
code:0000D549 jnz code_D552

Are you sure you dumped correctly all flash memory?

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DLLs loading sequence	te$ter	General Discussion	6	10-30-2013 18:52
Why the site is loading so slowly?	giv	General Discussion	10	05-17-2011 07:18
Ollydbg loading problem	hobferret	General Discussion	5	07-07-2008 20:40
Loading BIOS from dos debug - possible ?	petar	General Discussion	9	03-14-2005 00:26

All times are GMT +8. The time now is 01:23.