Help With SoftIce

In fact the nmake is program for automation of program compilation. It is part of (I think) every C compiler. Here it has debug info turned on (in the makefile), so when you debug it, you'll see to which lines the code belongs to. Also you need the exe to be run in the directory where sources are located. This means that this can be done only with programs, that you have with full source code. But this situation is quite rare in reality
The benefit is that you'll learn the basics.

To compile it, you have to load environment variables for your compiler, then run nmake with the right parameters (nmake /f makefile).
Good luck,
least

Thanks least. That��s interesting information. I found a printout of GDIDEMO done in C++ and I have installed Borland Turbo C++ (ver 3.0). With a little bit of luck I should be able to create the program and run the tut. Any suggestions?
Thanks,
d

Suggestions? Well, check a mail
You should have two new things there (gdidemo too).

PS. Isn't that C you installed for DOS? If yes then you probably will have problems, since the program is made for windows(95 at least I think).

Ok least. I checked mail, nothing there except ads. If you sent something it didn't make it. Yes you're right. C was for dos...I didn't think about that. I also downloaded some other versions from ftp but haven't had time to work with yet. Also I checked my e-mail address and it seems to be ok.

Thanks again,
d

OK, I'm resending it now. If it won't make it, let me know and I'll make it another way
Regards,
least

Thanks again least. I checked my profile again and made sure that the vcard option was available and worked with correct information. Nothing has come through yet but I'll keep checking.

Many thanks again,
d

Sent again, from different mail; if nothing comes again, PM me your email again and I'll try again. BTW VMWARE with keygen and DOS disks are on the FTP.